Skip to main content
Reg. Price:
Sale Price:
back add to cart


  • 600 lb weight capacity
  • 5 Year Warranty
MAC's Vertical Home Lift Specifications
The MAC's Vertical Home Lift was designed and engineered for home use. It's easy to operate easy to install and virtually maintenance free. Every safety detail has been carefully designed into the MPL-72, including a non-slip platform, constant pressure switches, a low platform for easy roll-on/roll-off, safety barrier and railing, and rolled edges.

The MPL-72 is sturdy enough to lift and lower up to 600 pounds and will accommodate electric wheelchairs and scooters. Running on a gear box and chain, the MPL-72 provides a smooth and quiet up and down ride, requiring little maintenance. All mechanics are fully enclosed, yet easy to access through the rear or front of the housing unit. The lift is completely weatherized and attractively finished in off-white. Shipped fully assembled, the MPL-72 installs in 6 easy steps. The Mac's Vertical Home Lifts are the economical and practical answer to stair barriers.

Five (5) year limited warranty.

Safety Devices
The unit shall have the following safety features for protection of users and the general public:
 Upper and lower limit switches
 Instant Reverse Motor
 Powered with 110 volt AC current, by 1/2 HP motor, 6.4 Amp
 Grounded electrical system
 Heavy duty worm drive gear box with heavy duty #50 lifting chain
 Automatic access ramp
 36" guard rails on non-enter and exit sides of platform
 Non-Skid platform and access ramp surface
 Key-lock control
 Switching & Control system 24 VAC low voltage current Installation

Composition of Materials
Machine tower: 14 gauge cold rolled steel.
Base frame: 1 1/2" square x 3/16" Structural steel tubing.
Lift weldment: 1 1/2" x 3" x .188" wall structure steel tubing.
Tower cap: 10 gauge cold rolled steel plate
Side Guard Rails: 1" round x .120" gauge steel tubing (frame).
Platform: 14 gauge cold rolled steel plate with slip resistance surface.
Access ramp: 11 gauge steel plate with slip resistance surface.
Electrical box: 16 gauge galvanized steel
Switch box: Hi-impact A.B.S. Thermoplastic instrument case.
Limitations: Vertical platform lift shall operate both indoors and out, and must be anchored on a level, 4" thick, 3500 psi reinforced concrete surface or pad.

Electrical System & Wiring:
The unit shall be pre-wired by manufacturer with exterior grade thermoplastic coated wiring. Extension Cord, 14 gauge UL-CSA approved is recommended if power source is not within three (3) feet of Machine tower. Machine may also be wired using water proof conduct.

Order Form

Gate Options
32" Upper Landing Gate (add $425.00)
32" Platform Gate w/ 48" Solid Sides (add $850.00)
Misc Options
Solid Side Panels (add $350.00)
Door Strike for gate/door (add $350.00)
Emergency Stop Switch (add $175.00)
Call/Send Switches (2) (add $210.00)
Safety Pan (add $395.00)
90 Degree Exit (add $395.00)
add to cart
2019 Discount Mobility Lifts International

Site Powered By:
Make Your Own Website